Proposal Number PSDF #P09-0004
Paints: Approved paints are PPG and DuPont other may be considered.
STAINLESS STEEL APPARATUS BODY PAINTED
The following apparatus body components shall be painted job color.
The rear wheel fender panels
The front body corner panels
The rear body corner panels
The exterior surface of the hose bed side walls/coffin compartment
The exterior surface of the hose bed/coffin compartment front wall
LETTERING
The lettering shall be done in 24 karat gold leaf and shall be to the direction of the fire chief. All lettering
must be done by East Coast Artie’s in Surfside Beach, SC.
REFLECTIVE SAFETY STRIPE
A 4" wide 3M brand Scotchlite reflective stripe shall be affixed to the perimeter of the vehicle. The striping
shall be placed up to 60" above ground level and shall conform to NFPA reflectivity requirements. At least
60% of the perimeter length of each side and width of the rear and at least 25% of the perimeter width of the
front of the vehicle shall have reflective stripe.
BODY STRIPE UP AND OVER REAR AXLE
The stripe on each side of the apparatus shall run straight back to the body, then angle up at approximately a
45 degree angle on the front body door and then run straight back from there to the rear of the body.
REFLECTIVE STRIPE COLOR
The apparatus body striping shall be BLACK reflective.
REAR BODY REFELCTIVE CHEVRON STRIPING
Red and bright yellow chevron reflective striping shall be provided and applied to the rear of the apparatus
body on the rear exterior face of the left and right side compartments only (not in the center inset area of the
apparatus). The stripes shall be 4" wide and shall alternate red and bright yellow. The chevron pattern shall
angle up from the outer edges toward the center of the rear body.
REAR DOOR REFLECTIVE CHEVRON STRIPING
Red and bright yellow reflective chevron striping shall be provided and applied to the rear door(s). The
stripes shall be 4" wide and shall alternate red and bright yellow. The chevron pattern shall angle up from
the outer edges toward the center of the rear body.
RADIOS
A Motorola model M28URS9PW1 M XTL 1500 mobile radio must be furnished and installed, along with a
G809 Analog, W484 3db Antenna, B-18 Speaker, G24 Two year Repair Service and Radio Programming.
