Dil ID: 12
Dil Adı: portugal
Dil Kodu: pt4tayfun Produtos da Marca Audiovox
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



Proposal Number PSDF #P09-0004
The signal patterns of the device shall be progressive left, progressive right, center out, and emergency “All
Flash.”
The switch control box is to be mounted in the cab allowing for easy operation by the driver.
IDENTIFICATION AND SAFETY LABELS
A permanent plate shall be installed in the driver's compartment to specify the quantity and type of the
following fluids in the vehicle:
1. Engine oil.
2. Engine coolant.
3. Transmission fluid.
4. Pump Transmission Lubrication Fluid.
5. Pump Primer Fluid (If applicable).
6. Drive Axle Lubrication Fluid.
7. Air-conditioning refrigerant.
8. Air-conditioning lubrication oil.
9. Power steering fluid.
10. Transfer case fluid.
11. Equipment rack fluid.
12. Air compressor system lubricant.
13. Generator system lubricant.
A permanent plate with pump performance data and serial numbers shall be installed on the pump panel.
A permanent plate shall be installed in the driver's compartment specifying the maximum number of
personnel the vehicle is designed to carry per NFPA standards. It shall be located in an area visible to the
driver.
An accident prevention sign stating "DANGER PERSONNEL MUST BE SEATED AND SEAT BELTS
MUST BE FASTENED WHILE VEHICLE IS IN MOTION OR DEATH OR SERIOUS INJURY MAY
RESULT" shall be placed so it is visible from all seating positions.
An accident prevention sign stating "DANGER DO NOT RIDE ON REAR STEP WHILE VEHICLE IS IN
MOTION, DEATH OR SERIOUS INJURY MAY RESULT" shall be placed so it is visible from the rear
step of the vehicle.
If an inlet located at the pump operators position is valved, it shall be provided with a permanent label with
language per NFPA-1901, current edition.
WHEEL CHOCKS
One (1) pair of heavy duty, high tensile molded aluminum wheel chocks measuring 7.75" high x 8.5 wide x
15" long shall be provided with the apparatus. The wheel chocks shall have a bright yellow powder coat
finish for high visibility, safety and corrosion resistance. No exception shall be allowed to these
requirements.
Two chock holders shall be provided and mounted on the left side of the apparatus below the front body
compartment.
Page 158