TOYOTA HIGHLANDER 2005 - OVERHEAD VIDEO(AUTOCINEMA)
SPECIAL NOTE:
Installation Sequences
Fig. B2
After TMS and Safety mandated preparatory
steps have been taken, the installation sequence
is the suggested method for completing the
accessory installation. In some instances the
suggested sequence is written for one associate
to install and in others the sequence is given as
part of a team accessory installation. Unless
otherwise stated in the document, the associates
may perform the installation steps in any order to Fig.C1
make the installation as efficient as possible
while maintaining consistent quality.
A. Pre-installation Precaution
1. Use Seat and Floor Protectors to avoid damage
to surfaces.
2. If the vehicle is equipped with an Anti-theft
radio, the radio code must be written down
prior to disconnecting the battery cable. The
code must be re-entered when the negative Fig.C2
battery cable is reinstalled.
B. Battery Disconnect
1. NOTE: be sure to open the rear hatch, PRIOR
to disconnecting the battery.
2. Remove the NEGATIVE (-) battery terminal
using a 10 mm socket before starting any dis-
assembly. (Fig. B1)
C. Domelamp removal
1. Using the panel removal tool, carefully pry
the domelamp lense from the housing as shown Fig.C3
in (Fig. C1)
2. Remove (2) screws with a #2 phillips head
screwdriver Fig. C2)
3. disconnect the wire harness and remove lamp
housing (Fig. C3)
19/12/03
