Article No. 01-6-2 Cont’d.
PATS DIAGNOSTIC (Continued)
System Types A
Action and D System Type B System Type C System Type E
Spare Key NOTE: REQUIRES NOTE: REQUIRES NOTE: REQUIRES NOTE: REQUIRES ANY
Programming ONE (1) ALREADY TWO (2) ALREADY TWO (2) ALREADY TWO (2) ALREADY
Procedure (i.e., to PROGRAMMED PROGRAMMED PROGRAMMED PROGRAMMED PATS
add an extra key) PATS KEY. PATS KEYS (KEY 1 PATS KEYS (KEY 1 KEYS (KEY 1 AND KEY
AND KEY 2). AND KEY 2). 2).
NOTE: REQUIRES NOTE: NUMKEYS NOTE: PATS PID NOTE: VIC/HEC NOTE: PATS PID
ONE (1) OR TWO PID MUST BE LESS SPARE_KY MUST = PID SPARE_KY SPARE_KY MUST =
(2) ALREADY THAN 16 TO BE ENABLE IN ORDER MUST = ENABLE IN ENABLE IN ORDER TO
PROGRAMMED ABLE TO ADD TO PERFORM THIS ORDER TO PERFORM THIS
PATS KEY(S) TO ADDITIONAL KEYS. PROCEDURE. IF PERFORM THIS PROCEDURE. IF
BE AVAILABLE. SPARE_KY = PROCEDURE. IF SPARE_KY = DISABLE,
DISABLE, THEN SPARE_KY = THEN USING THE
USING THE DISABLE, THEN SERVICE CARD...
SERVICE CARD... USING THE
SERVICE CARD...
NOTE: THIS 1) Use any Select: Select: Select:
PROCEDURE programmed key in
a) Service Bay a) Service Bay a) Service Bay Functions
REQUIRES B+ (HOT ignition, turn to RUN.
Functions Functions
AT ALL TIMES) TO
b) PCM
2) Within 5 seconds,
BE PRESENT AT
b) PATS b) VIC for Continental
remove programmed
THE PATS / VIC / c) Enter Security Access
key and turn new key
HEC / ICM / PCM / c) Enter Security or (10 minute delay)
to RUN. Theft
SCIL (WHICH IS Access (10 minute
indicator will HEC for Town Car, d) SPARE KEY SWITCH
NOT NECESSARY delay)
prove-out for 2 Expedition, F-Series, ENABLE. This will toggle
FOR VEHICLE
seconds and new key d) SPARE KEY and Navigator the PATS PID
STARTING AS THE
will start vehicle. SWITCH ENABLE. SPARE_KY = ENABLE.
RUN/START
or
This will toggle the
CIRCUIT IS USED
3) Repeat for any NOTE: NUMKEYS PID
PATS PID
AT THAT TIME). ICM for LS and
additional keys. MUST BE LESS THAN
SPARE_KY =
Windstar
8 TO BE ABLE TO ADD
ENABLE.
ADDITIONAL KEYS.
c) Enter Security
NOTE: NUMKEYS
Access (10 minute
PID MUST BE LESS
delay)
THAN 8 TO BE
ABLE TO ADD c) SPARE KEY
ADDITIONAL KEYS. SWITCH ENABLE.
This will toggle the
PATS PID
SPARE_KY =
ENABLE.
NOTE: NUMKEYS
PID MUST BE LESS
THAN 8 TO BE
ABLE TO ADD
ADDITIONAL KEYS.
1) Turn Key 1 to 1) Turn Key 1 to 1) Turn Key 1 to RUN.
RUN. RUN.
PAGE 16
