
14
Operating and control elements
1ON/OFF button (toswitchtheapplianceonando)
2Temperature setting buttons
3Set button (Enter)
4Audible warningon/obutton
5Display
Symbols in the display
Compressor is running
LEDashing-refrigerationunitswitchesonafteradelay.The
compressor will start automatically after the pressure in the
refrigerant circuit has equalised.
Fan is running
Appliance is defrosting
Alarm function
If appears in the display, the appliance has a fault. Consult
your nearest customer service point.
Switching the appliance on and o
Connect the appliance to the mains - the display reads OFF.
To switch the appliance on
Press the ON/OFF button for approx. 5 seconds so that
the temperature display lights up.
To switch the appliance o
Keep the ON/OFF button pressed for approx. 3 seconds - the
display reads OFF.
Setting the temperature
•Pressbutton 1 sec. The temperature display flashes.
•Toincreasethetemperature(warmer):pressbutton
.
•Toreducethetemperature(colder):pressbutton
.
•Pressbutton
again.
The desired temperature setting is saved.
Audible warning signal
- This sounds when the door has been left open for
longer than 240 seconds. The audible warning device
is switched off by pressing the Alarm button.
- It sounds when the interior gets too warm. The temperature
display will also flash. The audible warning device is switched
off by pressing the Alarm button.
LED
onconstantly.Anerrorcode(E0,E1,LO,HI,EE)will
appear in the display at the same time. Consult your nearest
customer service point.
Iftoolargequantitiesofwarmfoodareputintheapplianceatthe
same time or the door is left open for a long time, the temperature
willincreaseandLED
willlightup(thedisplaywillreadHI).
This does not mean that the appliance is faulty.
Checkthedisplayagainafterafewhours.Ifitisstillindicatingan
alarm, contact your customer service department.
Defrosting
The refrigerator defrosts automatically. The defrost water drains
into an evaporation tray near the refrigeration unit, where the heat
from the compressor causes it to evaporate.
Activating the defrost function manually
Ifthedoorhasbeenleftslightlyopenforalongtime,alayerof
ice may form in the interior and on the cooling plate. The defrost
function can then be activated manually.
• Pressbutton
for 5 seconds.
•TheLED
will come on.
Onetheapplianceisdefrosted,theappliancewillswitchbackto
normal mode automatically.