39
Connecting to the mains water supply
o Connect and fully tighten the inlet hose to the threaded inlet
valve that is located at the rear of the washer dryer. You should
connect the end with the right angle connector on it to the back
of your appliance.
o Connect the other end of the inlet hose to
your mains water supply. This machine only
uses cold water therefore only one hose is
needed to connect to the cold water supply.
DO NOT CONNECT TO A HOT WATER
SUPPLY.
o Tighten the inlet hose to your mains supply
fully.
o Test for any leaks.
Water outlet
o Secure the drain hose, so that it cannot move whilst the washer
dryer is in use.
o Place the end of the drain hose on your drain pipe. Push it a
short way down into your drain pipe.
