
4 of 4 BII 45424 (1103) © 2011 American Honda Motor Co., Inc. – All Rights Reserved.
10. Loosely secure the left rear splash guard to the rear
bumper with a 5 x 20 mm self-tapping screw.
LEFT REAR
SPLASH GUARD
SELF-TAPPING SCREW,
5 x 20 mm
(Install loosely.)
REAR
BUMPER
11. While holding the left rear splash guard against the
rear bumper, tighten the four self-tapping screws in
the order shown. Make sure there is no gap or
looseness between the left rear splash guard and
the vehicle. If there is, loosen the four self-tapping
screws, adjust the splash guard to remove the gap or
looseness, and retighten the screws.
12. Repeat steps 6 thru 11 to install the right rear splash
guard.
LEFT REAR
SPLASH
GUARD
REAR
BUMPER
3
2
1
4