
2 of 4 BII 45424 (1103) © 2011 American Honda Motor Co., Inc. – All Rights Reserved.
Installing the Front Splash Guards
1. Turn the steering wheel fully counterclockwise.
2. Remove the four self-tapping screws and one clip
from the left front inner fender.
FRONT
CLIP
(Discard.)
4 SELF-
TAPPING
SCREWS
LEFT FRONT INNER FENDER
3. Loosely secure the left front splash guard on the left
front inner fender with four self-tapping screws.
4. While holding the left front splash guard against the
left front inner fender, tighten the four self-tapping
screws in the order shown. Install the new clip. Make
sure there is no gap or looseness between the left
front splash guard and the vehicle. If there is, loosen
the four self-tapping screws and the clip, adjust the
splash guard to remove the gap or looseness, and
retighten the fasteners .
5. Turn the steering wheel all the way clockwise, and
repeat steps 2 thru 4 to install the right front splash
guard.
4 SELF-TAPPING
SCREWS
(reused)
LEFT FRONT
SPLASH GUARD
NEW CLIP
1
2
3
4
LEFT FRONT INNER FENDER