27. Now load the label stock.
28. Pass the label stock through the
rewinder from the bottom up.
Secure the label stock on the
rewinder using the retention clip.
【
Note
】
Make sure you choose the correct
rewind direction.
29. Replace the printer cover to
complete the installation.
【
Note 1
】
Before you start using the rewinder,
please make sure that you have
carried out all steps as shown in the
illustrations. Then send the command
"^XSET,REWINDER,1" to the printer to
enable the rewind function.
【
Note 2
】
To use the label dispenser, you have to
remove the rewinder guide again.
