4. Put the two ends of the inlet hose in a container
and let the water flow out of the hose.
5. Empty the drain pump. Refer to the emergency
drain procedure
6. When the drain pump is empty, install the inlet
hose again.
Warning! Make sure that the temperature is more
than 0 °C before you use the appliance again.
The manufacturer is not responsible for damages
caused by low temperatures.
Troubleshooting
The start of the appliance does not occur or it stops
during operation.
First try to find a solution to the problem (refer to the
table). If not, contact the service centre.
With some problems, the acoustic signals operate
and the display shows an alarm code:
•
- The appliance does not fill with water.
•
- The appliance does not drain the water.
•
- The appliance door is open or not closed
correctly. Please check the door!
•
- The mains supply is unstable. Wait until the
mains supply is stable.
Warning! Deactivate the appliance before you do
the checks.
Problem Possible solution
The programme does not start. Make sure that the mains plug is connected to the mains socket.
Make sure that the appliance door is closed.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the Start/Pause has been pressed.
If the delay start is set, cancel the setting or wait for the end of countdown.
Deactivate the Child Lock function if it is on.
The appliance does not fill with
water.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too low. For this infor-
mation, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter of the inlet hose and the filter of the valve are not clog-
ged. Refer to “Care and cleaning”.
Make sure that the inlet hose has no kinks or bends.
Make sure that the connection of the water inlet hose is correct.
The appliance does not drain
the water.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Make sure that the drain filter is not clogged. Clean the filter, if necessary. Re-
fer to 'Care and cleaning'.
Make sure that the connection of the drain hose is correct.
Set the drain programme if you set a programme without drain phase.
17
