Dil ID: 7
Dil Adı: french
Dil Kodu: fr1tayfun Produits de la Marque Whirlpool
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



22
Notes:
Optimumperformancelevelswhenusingthe“Rapid”cyclescan
be achieved by respecting the specified number of place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories: forinformationoncomparativeEN
testingconditions,pleasesendanemailtothefollowingaddress:
Special wash cycles
and Options
Half Load option/Child lock
If there are not many dishes to be washed, a half load
cycle may be used in order to save water, electricity and
detergent.SelectthewashcycleandpresstheHALFLOAD
button:theindicatorlightwillilluminate.
PresstheHALFLOADbuttontodeselectthisoption.
Remember to halve the amount of detergent.
Child lock
AlongpressofHALFLOADbutton,willactivatetheCHILD
LOCKfunction.TheCHILDLOCKfunctionwillblockthecontrol
panel.TodeactivatetheCHILDLOCK,longpressagain.
Sani Rinse option/Tab
This option allows higher temperatures to be used. Select
thewashingprogram,presstheSANIRINSEbuttonand
the indicator light will switch on. To deselect the option, press the
same button again.
Ideal to clean crockery and feeding bottles.
Warning: the crockery and plates could be extremely hot at the
end of the cycle.
TheSANIRINSEoptionresultsinlengtheningofthewashcycle.
Tablet option (Tab)
A long press of Sani rinse button, will activate the TAB
function. This option optimises washing and drying results.
To deactivate the TAB option, long press again.
The TAB option results in a longer wash cycle.
Drain out
To stop and cancel the active cycle, the DRAIN OUT
function can be used.
A long press of START/PAUSE button, will activate the DRAIN
OUTfunction.Theactivecyclewillbestoppedandthewaterin
the dishwasher will be drained out.
Wash options
The OPTIONS may only be set, changed or reset after the wash
cycle has been selected and before the Start/Pause button
has been pressed.
Only the options which are compatible with the type of wash cycle
set may be selected. If an option is not compatible with the selected
wash cycle
(seeTableofwashcycles)
,thecorrespondingled/
symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previouslyselected)option,itwillflash3timesandswitchoff,
while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press the
corresponding button again.
Delayed start
The start of the program may be delayed for
a period of time between 0:30 and 24 hours.
1. Select the program and any desired options. Press the
DELAYEDSTARTbutton(repeatedly)todelaythestartofthe
program.Adjustablefrom0:30to24hours.
With each press of the button, the delay start increases
by: 0:30 if selection below 4 hours, 1:00 if selection is be-
low 12 hours, 4 hours if selection is above 12 hours. If 24
hours reached, and the button is pressed, the delayed start is
deactivated.
2. Press the START/PAUSE button: the timer will begin
counting down;
3. Once this time has elapsed, the indicator light switches
off and the program begins automatically. If at the time of
thecountdowntheSTART/PAUSEbuttonispressedagainthe
DELAYEDSTART option is cancelled and the selected pro-
gram starts automatically.
The Start Delay function cannot be set once a wash cycle
has started.