Produits de la Marque Whirlpool

Care and maintenance

Shutting off the water and electricity supplies

• Turnoffthewatertapaftereverywashcycletoavoidleaks.

• Alwaysunplug the appliance when cleaning it and when

performing maintenance work.

Cleaning the dishwasher

• The external surfaces of the machine and the control panel

can be cleaned using a non-abrasive cloth which has been

dampened with water. Do not use solvents or abrasive products.

• Anymarksontheinsideoftheappliancemayberemovedusing

a cloth dampened with water and a little vinegar.

Preventing unpleasant odours

• Alwayskeepthedooroftheapplianceajarinordertoavoid

moisture from forming and being trapped inside the machine.

• Clean the seals around the door and detergent dispensers

regularly using a damp sponge. This will avoid food becoming

trapped in the seals, which is the main cause behind the

formation of unpleasant odours.

Cleaning the spray arms

Food residue may become encrusted onto the spray arms

and block the holes used to spray the water. It is therefore

recommended that you check the arms from time to time and clean

them with a small non-metallic brush.

The two spray arms may both be removed.

To remove the upper spray arm, turn

the plastic locking ring in an anti-

clockwise direction. The upper spray

arm should be replaced so that the

side with the greater number of holes

is facing upwards.

The lower spray arm can be removed

by pressing on the side tabs and

pulling it upwards.

Cleaning the water inlet hose

If the water hoses are new or have not been used for an extended

period of time, let the water run to make sure it is clear and free

of impurities before performing the necessary connections. If this

precaution is not taken, the water inlet could become blocked and

damage the dishwasher.

Clean the water inlet filter at the tap outlet regularly.

- Turn off the water tap.

-Unscrewtheendofthewaterinlethose,removethefilterand

clean it carefully under running water.

- Re-place the filter and screw the water hose back into position.

Cleaning the filters

The filter assembly consists of three filters which remove food

residues from the washing water and then recirculate the water.

They must be cleaned if you wish to achieve the best results in

every wash.

Clean the filters regularly.

The dishwasher must not be used without filters or if the filter

is loose.

•Afterseveralwashes,checkthefilterassemblyandifnecessary

clean it thoroughly under running water, using a non-metallic brush

andfollowingtheinstructionsbelow:

1. Turn the cylindrical filter C in an anti-clockwise direction and

pull it out

(fig.1).

2. Remove the cup filter B by exerting a slight pressure on the

side flaps

(fig.2);

3. Slide out the stainless-steel plate filter A.

(fig.3).

4. Inspect the trap and remove any food residues. NEVER

REMOVE the wash-cycle pump protection

(blackdetail)(fig.4).

After cleaning the filters, re-place the filter assembly and fix it in

position correctly; this is essential for maintaining the efficient

operation of the dishwasher.

Leaving the machine unused for extended

periods

• Disconnecttheappliancefromtheelectricitysupplyandshut

off the water tap.

• Leavethedooroftheapplianceajar.

• When you return, run a wash cycle when the dishwasher is

empty.