10
Using the Wearable Microphone
1. Remove the Microphone from the Charger Base. The
Microphone turns on and mutes automatically when removed
from Charger Base (flashing RED LED).
2. The Wireless Microphone has a clip on the back which allows
the Microphone to be easily clipped onto a shirt pocket, blouse
or lapel. The Microphone can also be clipped on to a lanyard
and be worn around the neck. Attach the Microphone as close
to the mouth as possible (within 6 - 12 inches is
recommended).
3. With the Microphone in the wearing position, un-mute the
Microphone by pressing and releasing the MUTE button
(confirm by viewing the flashing GREEN LED on both the
Microphone and Charger Base).
4. To turn off the Microphone, return it to the Charger Base. You
may also turn it off manually by pressing and holding the MUTE
button for approximately10 seconds until the LED turns solid
RED and then releasing the mute button.
5. If the Microphone is moved out of range of the Charger Base
(~65 feet) the connection will be dropped and the Microphone
will mute (LED flashes alternating RED, YELLOW and
GREEN). After 15 seconds the microphone will beep 5 times,
and will continue beeping every 30 seconds to remind the user
to return the microphone. If the microphone is moved back into
range within 5 minutes the connection will automatically be re-
established to its original state, and the beeping will cease. If
not, the microphone will turn off after 5 minutes.
Using the TableTop Microphone
1. Remove the microphone from the Charger Base. The
microphones turn on and mute themselves automatically when
removed from Charger Base (flashing RED LED), to reduce
noise while placing the microphone on the table.
2. The TableTop microphone should be centered on the table in
front of users, between 2 to 5 feet (.75 to 1.75m) away. It is
always better to have the microphone as close to the person
speaking as possible, but avoid placing the microphone where it
might be blocked by laptops or meeting paperwork.
11
3. With the microphone in position, un-mute the microphone by
pressing and releasing the MUTE button (confirm by viewing
flashing GREEN LED).
4. To turn microphones off, return the microphone unit to the
Charger Base or press and hold the MUTE button for ~10
seconds until the LED turns solid RED and release button.
5. If the microphones are placed too far from the Base Station
(~100 feet (30 meters)) the connection will be dropped (LED
flashes all colors) and the microphone will mute. After 15
seconds the microphone will beep 5 times, and will continue
beeping every 30 seconds to indicate that it is out of range.
Move the microphone closer to the Base Station and the
connection will automatically be re-established to its original
state, and the beeping will cease. If not, the microphone will
continue beeping until it turns off in about 15 minutes.
Adjusting the Volume
The volume of the Microphone is set at the factory and cannot be
adjusted on the Wireless Microphone. It may be possible to
change the volume on computer or IP calls by adjusting the
software control parameters (see Computer Software Settings,
below).
Note: Moving the Microphone closer to the mouth will increase the
volume.
To change the volume on the earpiece,
use the dial on the earpiece wire.
Turning the dial towards the earpiece
will increase the volume, and turning
the dial towards the Microphone will
decrease the volume.
