~
If the boiler has been programmed
to "BOILER READY", be particularly
careful of hot water and steam when
opening the door. Danger of burning or
scalding. The water inlet pipe to the
wash cabinet is located, as viewed
from the unclean side, underneath the
basket runner on the left hand side.
~
Steam heating is permissible up to a
pressure of 145 psi. This corresponds
to a water steam temperature of 354°F
(179 °C).
~
Never clean the machine or near its
vicinity with a water or high pressure
hose.
~
Avoid inhaling powder products.
They can cause burning in the mouth
and throat if swallowed, and can inhibit
breathing.
~
Before servicing, disconnect the
power supply by either removing the
fuse, unplugging the unit or manually
"tripping" the circuit breaker.
~
Whenever work is conducted on the
tap water network, the water supply line
to the washer must be cleared of air.
Failure to do so can result in damage to
the water softener.
The following points should be
observed to assist in maintaining
quality standards for critical labware
and to avoid damage to the loads
being cleaned.
~
For this type of cleaning, the
program must not be interrupted until
completion. In other words, the On/Off
Button must not be used. Interruptions
should also be avoided for all other
programs, such as during performance
testing, because this can negatively
affect the cleaning and rinsing results.
After any interruption, the program
should be restarted from the beginning.
~
Only use cleaning agents
formulated for special processes and
approved by Miele for use with this
machine. Use of unsuitable cleaning
agents could adversely affect the
components of the machine.
~
Use only Miele approved cleaning
agents with this machine. Use of
unsuitable cleaning agents could
adversely affect the components of the
machine. Damages resulting from using
unsuitable cleaning agents are not
covered by the warranty.
~
Pre-treatments with cleaning agents
can create suds, as can certain rinsing
agents. For pre-treatment and / or
cleaning, only use low-sudsing
detergents which have been approved
by Miele. Suds can have an adverse
effect on the cleaning process.
~
In critical applications where very
high requirements have to be met, it is
strongly recommended that all the
relevant factors for the process, such
as cleaning agent, quality of water, etc.
are discussed with the Miele
Applications Specialists.
IMPORTANT SAFETY INSTRUCTIONS
6
