Issue Date: 2010-03-02 Page 2 of 23 Report Reference # E336418-A29-UL
2010-10-22
IEC 60950-1
Clause Requirement + Test Result - Remark Verdict
1.5.7.3
Bridging resistors N/A
1.5.7.4 Accessible parts Accessible conductive parts
separated from other parts by
DOUBLE or REINFORCED
INSULATION bridged by CY1
comply with the requirements
for LIMITED CURRENT
CIRCUITS.
Pass
1.5.8 Components in equipment for IT power systems N/A
1.6 Power interface Pass
1.6.1 AC power distribution systems AC power distribution systems
are classified as TN.
Pass
1.6.2 Input current The steady state input current
of the equipment did not
exceed the RATED CURRENT
by more than 10% under
NORMAL LOAD.
(see appended table 1.6.2)
Pass
1.6.3 Voltage limit of hand-held equipment N/A
1.6.4 Neutral conductor The neutral conductor was
served as a line conductor.
Pass
1.7 Marking and instructions Pass
1.7.1 Power rating Rating marking readily visible
to OPERATOR.
Pass
Rated voltage(s) or voltage range(s) (V)............... : Refer to the Rating information
at the beginning of this Test
Report.
Pass
Symbol for nature of supply, for d.c. only.............. : N/A
Rated frequency or rated frequency range (Hz).... : Refer to the Rating information
at the beginning of this Test
Report.
Pass
Rated current (mA or A) ........................................ : Refer to the Rating information
at the beginning of this Test
Report.
Pass
Manufacturer's name or trademark or identification
mark....................................................................... :
GLOBTEK INC / E170507 Pass
Type/model or type reference ............................... : Refer to the Model information
at the beginning of this Test
Report.
Pass
Symbol for Class II equipment only....................... : N/A
Other symbols ....................................................... : Additional symbols/markings
do not give rise to
Pass
