Dil ID: 7
Dil Adı: french
Dil Kodu: fr1tayfun Produits de la Marque Asko
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



Page 3
UNIT DIMENSIONSUNIT DIMENSIONS
UNIT DIMENSIONSUNIT DIMENSIONS
UNIT DIMENSIONS
US European
Measure Measure
Height 32-1/4"–35-1/2" 825–900 mm
Width 24" 610 mm
Depth 22-7/16" 570 mm
Weight 104 lb 48 kg
CABINET OPENINGCABINET OPENING
CABINET OPENINGCABINET OPENING
CABINET OPENING
US European
Measure Measure
Height 32-1/4"–35-1/2" 825–900 mm
Width* 24" 610 mm
Depth 22-7/16" 570 mm
The best place for your dishwasher is in the kitchen
near the sink. This makes it easier to connect the water
and drain supply lines.
A built-in dishwasher must be enclosed on the top,
both sides and the back.
*
Models 1805 FI and 1895 do not have fill strips. The
width for these models is 23-1/2” (596 mm).
Under-Counter Space Needed
INSTINST
INSTINST
INST
ALLING ALLING
ALLING ALLING
ALLING
THE THE
THE THE
THE
TIP GUTIP GU
TIP GUTIP GU
TIP GU
ARDSARDS
ARDSARDS
ARDS
(OPTIONAL)(OPTIONAL)
(OPTIONAL)(OPTIONAL)
(OPTIONAL)
When it is not possible to fasten the dishwasher to the
cabinet, you should install tip guards to prevent the
machine from tipping when the door is opened. The tip
guards can be attached either to the floor or the wall.
The tip guards should be mounted behind the machine,
19” apart (measuring center to center) and 18-1/2” from
the front of the machine. (Note: This measurement
could vary, depending on the thickness of the custom
panel, if any.)
Tip Guards
(P/N 8070851)
Rear
We recommend that you install tip
guards when it isn’t possible to fasten
the dishwasher to the cabinet.
PREPPREP
PREPPREP
PREP
ARING ARING
ARING ARING
ARING
THE LTHE L
THE LTHE L
THE L
OCAOCA
OCAOCA
OCA
TIONTION
TIONTION
TION
DIMENSIONSDIMENSIONS
DIMENSIONSDIMENSIONS
DIMENSIONS
The kick plate supplied with your dishwasher will fit a 24"
opening. When using European standard installation, a
kick plate is available from your ASKO dealer. (Part
Numbers: White=8057528-0; Black=8057528-29)
The electrical and water supplies should enter through
the area indicated by the shading on the illustration
above. They should come through the right side of the
machine, a maximum of 2” from the back wall and 7” to
9” from the floor, depending on the underneath cabinet
height.
Access holes must be round and smooth, and they
must be no bigger than 1-1/2" in diameter.