
Page 2
TOOLSTOOLS
TOOLSTOOLS
TOOLS
1) Phillips No. 2 screwdriver
2) Flat blade screwdriver
3) Torx screwdriver size T 20
4) Adjustable wrenches (if you use copper fittings)
5) Open-ended wrench (1/2" [12 mm] or 5/8" [16 mm])
6) Wire cutters and strippers
7) Tape measure
8) Spirit level
9) Electric drill with 1” drill bit
10) Keyhole saw
TECHNICAL DTECHNICAL D
TECHNICAL DTECHNICAL D
TECHNICAL D
AA
AA
A
TT
TT
T
AA
AA
A
Water pressure 18-176 psi
Power 120 v, 60 Hz, 15 amp.
Heating element 1400 w
Max loading 1650 w
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
MAMA
MAMA
MA
TERIALSTERIALS
TERIALSTERIALS
TERIALS
♦ Minimum 3/8" OD copper tubing of sufficient length
for your installation
♦ Shut-off valve and fittings for water supply line
♦ 1 compression nut
♦ 1 compression sleeve
♦ 1 90° street elbow
♦ 1 90° compression elbow, 3/8" (10 mm) OD
Read these instructions carefully and completely before
you install the machine. The installation should be
carried out by a qualified person who is familiar with all
local codes and ordinances for electrical and plumbing
connections.
If a dishwasher is being installed in this area for the
first time, most of the cabinet work, plumbing, and
electrical has to be done before you move the machine
into place.
NOTE:
Cosmetic damage must be reported to the
ASKO dealer within five days from the date of purchase.
After unpacking the dishwasher, thoroughly check the
unit for cosmetic damage.
If you are replacing an old dishwasher, you must check
the plumbing connection and wiring before you move
the new dishwasher into place.
Tip Guards (optional)Tip Guards (optional)
Tip Guards (optional)Tip Guards (optional)
Tip Guards (optional)
When it is not possible to attach the
dishwasher to the cabinet, you
should install tip guards to prevent
the machine from tipping when you
open the door.
Refer to page 3 for installation
instructions.
Tip Guards
(P/N 8070851)
INTRODUCTIONINTRODUCTION
INTRODUCTIONINTRODUCTION
INTRODUCTION
WHAWHA
WHAWHA
WHA
T T
T T
T
YY
YY
Y
OU NEEDOU NEED
OU NEEDOU NEED
OU NEED