ARISTON DISHWASHER - Instructions for installation and use
15
D
1509)50-4
You have loaded your dishes and you now have to set the
wash cycle. It takes just one minute to learn how
Starting the dishwasher
Ready, steady, go!
First of all.
Insert the plug into the
electricity socket to power the
dishwasher. Turn on the water
tap completely and press the
Stand-by button
. The display
turns on and 4 dashes appear: these
indicate that the dishwasher is
awaiting instructions.
Selecting the wash
cycle
Select the wash cycle
by pressing this button
Each time you press the button,
a beep will sound and the
corresponding symbols will light up
in sequence:
choose the cycle you deem most
suited to the type of dishes to be
washed (take a look at page 18,
where you will find the wash cycle
table). Keep the Start button
pressed for a few seconds and the
wash cycle begins, but if you have
left the dishwasher door open, the
word DOOR will be displayed;
shut it and press the same button
again.
A beep sounds and then the
wash cycle begins and only the
symbol corresponding to the
wash cycle selected is
displayed.
You can see the amount of time
left until the end of the wash
cycle on the counter. Do not
expect a precise countdown as
the wash cycle starts with an
estimated cycle time that is
updated, thanks to the sensor
it is fitted with, as the cycle
progresses, according to a
number of parameters that
ensure maximum wash
efficiency.
The dishwasher
keeps you informed.
Your dishwasher is fitted with
indicator lights (H)
which light up to
indicate the cycle
phase under way.
Here are the symbols
corresponding to each
cycle phase:
At all times, your
dishwasher tells you
which cycle phase is under way.
Modifying a wash
cycle in progress.
But if you have chosen the wrong
cycle, not to worry! You can modify
the wash cycle in progress, if it has
only just started. Keep the Reset
button
pressed for about 2
seconds: a prolonged beep will
sound, followed by three short
beeps. Indicator light I turns off
and the 4 dashes appear to indicate
that all the settings have been
cancelled. You are now free to re-
set the correct wash cycle.
Youve left out a dish?
Well, it happens to everyone.
Interrupt the wash cycle by
pressing the Stand-by button, insert
the dish you had forgotten and
press the same button again. The
cycle will start up from where you
interrupted it.
P
Make sure the wash
cycle has ended before
removing the dishes!
Finished?
The end of the wash cycle is
indicated by two short beeps and
the word END flashes on the
display.
Turn off the water tap.
Wait a few minutes before
unloading the dishes: they are very
hot! If you wait a little while, they
dry better.
Empty the lower rack first.
Theres been a power
failure? Have you
opened the dishwasher
door?
The wash cycle stops and then
restarts when the electricity comes
back on or when you shut the door.
Everything is under control!
Have you left the
dishwasher door open?
The word DOOR flashes on the
display. Shut the appliance door and
the wash cycle will start up again.
Warning:
Turn the display off by pressing
button A, unplug the appliance
from the electricity socket to cut
off the power supply; the power
supply cable should
consequently be easily
accessible.
