If the water tap is a screw type, assemble a water supply hose that fits to the tap as shown.
After completing connection, if water leaks from the hose, then repeat the same steps.
If after completing the connection water leaks from
the hose, repeat the same steps again. Use the most
conventional type of faucet for the water supply. If the
faucet is square or too big, remove the spacing ring before
inserting the faucet into the adaptor.
Assembling the Protection Panel (Optional)
1. Push and insert the Protection panel towards the back
through the insert hole from the front.
2. If you have difficulty inserting the panel, lift the washer up a
little and then insert it.
The protection panel is not applied in some models
Connecting the drain hose
For non-pump drained washers
1. Press the joint ring and place it around the drain hose.
2. After placing the drain hose into a drain outlet, join the other
end of the hose to the drain outlet of the washer.
3. Ensure that they are connected tightly by pressing the joint
ring and pushing it into the drain-outlet.
• The length of drain hose is adjustable so that it can be
extended to the appropriate length.
Changing the direction of the drain hose
• Press the handle of the joint ring to pull out the drain hose.
Change the direction of the drain hose and follow the above
guidelines again.
