No. TITLE
INITIAL REFFERENCE INITIAL SETUP
RANGE OF DATA FUNCTION
DATA DATA
46 VL 4 4 0~7 Video Level
47 EWD 39 39 0~63 EW DC.
48 EWA 30 30 0~63 EW Amp.
49 EWT 34 34 0~63 EW Tilt
50 EWP 7 7 0~7 EW Corner Top
51 EWB 8 8 0~7 EW Corner Bottom
52 HSC 7 7 0~7 Horizontal Size Comp.
53 SB 32 32 0~63 Sub Brightness
54 SCO 7 7 0~31 Sub Color
55 STI 20 20 0~31 Sub Tint
56 SSH 12 12 0~31 Sub Sharpness
57 OPT 0 100* 0~255 Option (See Note 1 page 6.)
58 OP2 0 32* 0~255 Option 2 (See Note 2 page 6.)
59 HR 27 27 0~63 OSD Horizontal Position
60 ATT 7 7 0~63 Input Level
61 WDB 32 32 0~63 Wideband
62 SPC 32 32 0~63 Spectral
63 SBO 5 6* 0~255 Sub Brighatness Offset
64 PCO 40 40 0~63 PIP Color
65 PTI 40 40 0~63 PIP Tint
66 PUV 24 24 0~63 PIP Top Position
67 PDV 147 147 0~255 PIP Bottom Position
68 PLH 40 40 0~63 PIP Left Position
69 PRH 101101 0~255 PIP Right Position
70 PCN 52 52 0~63 PIP Y level
71 PBS 15 15 0~63 PIP BGP Phase
72 DRV
64 64 0~127 Red Drive Adjustment (See Note 3 page 6.)
64 64 0~127 Blue Drive Adjustment (See Note 3 page 6.)
73
– 0 0 0~255 Red Bias Adjustment (See Note 4 page 6.)
– 0 0 0~255 Green Bias Adjustment (See Note 4 page 6.)
– 0 0 0~255 Blue Bias Adjustment (See Note 4 page 6.)
— 5 —
Table 1. ON-SCREEN SERVICE MENU (Continued)
When IC802 (EEPROM) is replaced, check the bus data to confirm they are the same as below. The shaded menu should be checked
and be set up or readjusted according to the procedures described in the following pages. Initial Setup Data marked with an * should
be changed from Initial Reference Data. (See page 3 for Initial Bus Data Setup.)
