7
3) Remove the four Cover Screws and two
Rear Shields from the Cutter
Assembly.
Cover Screws
Rear Shields
Cutter Assembly
(Cabling not shown for clarity.)
4) Remove the Cover from the Mechanism
and then, using compressed air (or a
brush), remove all debris.
Cover
Mechanism
5) Pressing on the Lever to gain access
and using a Cotton Swab dampened
with alcohol (see note below), wipe clean
the Fixed Blade, the Movable Blade,
and the other areas where adhesive has
accumulated.
Cotton Swab
Fixed
Blade
Movable
Blade
Lever
Note: Heavy deposits can be removed using WD-40
(or another non-damaging adhesive
remover) if carefully and sparingly applied using a cotton swab. Never spray directly onto
the assembly; severe damage can result.
