Depth cm 57,5
Electrical connection - Voltage -
Overall power - Fuse
Information on the electrical connection is given on the rating plate on
the inner edge of the dishwasher door.
Water supply pressure Minimum 0,5 bar (0,05 MPa)
Maximum 8 bar (0,8 MPa)
Capacity Place settings 12
Environment concerns
The symbol on the product or on its
packaging indicates that this product may not
be treated as household waste. Instead it
should be taken to the appropriate collection
point for the recycling of electrical and
electronic equipment. By ensuring this product
is disposed of correctly, you will help prevent
potential negative consequences for the
environment and human health, which could
otherwise be caused by inappropriate waste
handling of this product. For more detailed
information about recycling of this product,
please contact your local council, your
household waste disposal service or the shop
where you purchased the product.
The packaging materials are environmentally
friendly and can be recycled. The plastic com-
ponents are identified by markings, e.g. >PE<,
>PS<, etc. Discard the packaging materials in
the applicable container at the community
waste disposal facilities.
Warning! To discard the appliance, follow
the procedure:
• Pull the mains plug out of the socket.
• Cut off the mains cable and mains plug and
discard them.
• Discard the door catch. This prevents the
children to close themselves inside the appli-
ance and endanger their lives.
Installation
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Put the appliance adjacent to a water tap and a
water drain.
Install the appliance under a kitchen counter or
work surface.
Make sure that the dimensions of the recess
agree with the given dimensions.
No further openings for the venting of the dish-
washer are necessary, but only to let the water
fill, the drain hose and the power supply cable
pass through.
Make sure that there are no kinks in the water
hoses and that the water hoses are not squash-
ed.
Adjusting the height of the appliance
Do these steps to adjust the height of the appli-
ance:
1. Loosen or tighten the two front feet.
2. Loosen and remove the adjustable plinth.
3. Adjust the rear foot. Turn the screw in the
middle of the front kick plate to the left or
to the right.
14
www.zanussi.com
