The washing programme is cancelled.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme.
Fill the detergent dispenser with detergent
before you set a new washing programme.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point of
interruption.
End of the washing programme
When the programme is completed, the end in-
dicator comes on. If you do not deactivate the
appliance within 3 minutes, only the on/off indi-
cator stays on. This helps to decrease energy
consumption.
1. Deactivate the appliance. Turn the pro-
gramme knob until the programme marker
is aligned with the on/off indicator.
2. Close the water tap.
For better drying results, keep the door ajar for
some minutes before you remove the dishes.
Let the dishes cool down before you remove
them from the appliance. Hot dishes are easily
damaged.
Removing the load
• First remove items from the lower basket,
then from the upper basket.
• There can be water on the sides and door of
the appliance. Stainless steel becomes cool
more quickly than the dishes.
Care and cleaning
Warning! Switch the appliance off before
you clean the filters.
Cleaning the filters
Important! Do not use the appliance without
the filters. Make sure that the installation of the
filters is correct. Incorrect installation will cause
unsatisfactory washing results and damage to
the appliance.
1 2
Fully clean the filters
A, B and C below
running water.
3
To remove filters B
and C, turn the han-
dle approximately 1/4
anticlockwise.
4
Remove the flat filter
A from the bottom of
the appliance.
11
www.zanussi.com
