Make sure that the appliance is level to
close and seal the door correctly. If the
level of the appliance is correct, the door does
not catch on the sides of the cabinet. If the
door does not close correctly, loosen or tighten
the adjustable feet until the appliance is level.
Adjusting the height of the plinth
If there is a space at the bottom of the machine,
you can lower the plinth to cover it.
Adhesive steam protection foil
Fit the steam protection on the front part of the
worktop along the entire width.
Fixing to the adjacent units
Warning! Use the supplied brackets to
attach the appliance under the worktop or
to the adjacent units, to prevent injury or
damage.
1. Fit the supplied angular brackets in the
slots on the top of the appliance.
2. Use the supplied screws to secure the ap-
pliance in position (upwards or sideways).
Make sure the screws are tightened.
Water connection
Water inlet hose
Connected the appliance to a hot (max. 60°) or
cold water supply.
If the hot water comes from alternative sources
of energy that are more environmentally friendly
(e.g. solar or photovoltaic panels and aeolian),
use a hot water supply to decrease energy con-
sumption.
Connect the inlet hose to a water tap with an
external thread of 3/4”.
Caution! Do not use connection hoses
from an old appliance.
The water pressure must be in the limits (refer
to the chapter 'Technical data'). Make sure that
the local water authority gives you the average
mains pressure in your area.
Make sure that there are no kinks in the water
inlet hose and that the water inlet hose is not
squashed or entangled.
Turn the inlet hose to the left or the right to suit
the installation. Fit the locknut correctly to pre-
vent water leaks.
Caution! Do not connect the appliance to
new pipes or pipes that are not used for a
long time. Let the water run for some minutes,
then connect the inlet hose.
15
www.zanussi.com
