SECTION 4
OPERATOR MAINTENANCE
73
5. Remove the Service Station completely from the print engine and place it on a non-absorbent
surface (plastic bag) to protect the surface you are placing it on.
6. If you are replacing or re-installing the Service Station, please see the section titled
“Installing the Service Station”.
7. If you are cleaning or replacing items in the service station; please see the next section titled
“Cleaning the Service Station”.
WHENEVER POWERING DOWN UNIT, ALWAYS:
1. PRESS THE ON/OFF ON THE CONTROL PANEL.
2. WAIT FOR THE PRINTER TO STOP PROCESSING.
3. THEN PRESS THE MAIN POWER SWITCH ON THE REAR PANEL.
8. Slide the Service Station out of the Service Station
Dock. NOTE: Do not pull Station all the way out
until you disconnect the Ribbon Cable.
NOTE: It is a good idea to place an absorbent towel
under the Service Station as you remove it to
prevent any drips or leaks.
9. Disconnect the Ribbon Cable. Slide the Latch
open on the Service Station Circuit Board to release
the Ribbon Cable. Remove the Service Station.
