SECTION 5
TROUBLESHOOTING
106
Toolbox System Status Messages (continued)
Displayed, in red, in the MC Series Toolbox utility.
SYSTEM STATUS PROBLEM SOLUTION
One or more Ink Tanks
Ink Tank replacement will be necessary
soon. Reorder Ink
Example: INK_OUT_YELLOW
One or more Ink Tanks
are out of ink
Replace empty Ink Tank(s).
WARNING! Use proper procedure to
replace Ink Tank(s) to avoid damage.
See “Replacing the Ink Tanks” section.
Press the “Replace Ink Tanks” button,
then verify that Ink Tanks are seated
firmly and latches are fully closed.
Verify that the printer is on a stable,
level surface.
Try to clear the error by pressing
the “Refresh Ink Levels” button,
Printer is performing
maintenance.
No action is required. Wait for printer
to finish.
perform maintenance;
if error is shown in
combination with
“Reason: Uncapped
printhead or clamshell
open" and there is no
maintenance activity
(noise) coming from
Remove media from print engine. See
“Paperpath_Paperjam” solutions.
If problem continues clean Paperpath
Entry and Exit sensors.
If problem continues contact Service.
Missing Ink Tank, or Ink
Tank not being
recognized
Replace Ink Tank(s) using proper
procedure.
Insert missing Ink Tank.
Clean Ink Tank contacts as outlined in
“Operator Maintenance” section.
Clear error by pressing the “Refresh Ink
Levels” button in the Toolbox.
Reason: Sled lift failed
Reason: Ink valve failed
Reason: Sled home failed
sensor failure. One of
the printer’s mechanical
components was not
properly registered at the
If the Service Station was just installed;
check to be sure it was installed
properly.
Call for Service Support.
