6.
7.
2
1
8.
Emergency drain
Because of a malfunction, the appliance cannot drain
the water.
If this occurs, do steps (1) through (8) of 'To clean the
drain pump'.
If necessary, clean the pump.
When you drain the water with the emergency drain pro-
cedure, you must activate again the drain system:
1. Put 2 litres of water in the main wash compartment
of the detergent dispenser.
2. Start the programme to drain the water.
Frost precautions
If the appliance is installed in an area where the temper-
ature can be less than 0 °C, remove the remaining wa-
ter from the inlet hose and the drain pump.
1. Disconnect the mains plug from the mains socket.
2. Close the water tap.
3. Remove the water inlet hose
4. Put the two ends of the inlet hose in a container
and let the water flow out of the hose.
5. Empty the drain pump. Refer to the emergency
drain procedure
6. When the drain pump is empty, install the inlet
hose again.
Warning! Make sure that the temperature is more
than 0 °C before you use the appliance again.
The manufacturer is not responsible for damages
caused by low temperatures.
Troubleshooting
The start of the appliance does not occur or it stops dur-
ing operation.
First try to find a solution to the problem (refer to the ta-
ble). If not, contact the service centre.
With some problems, the acoustic signals operate
and the display shows an alarm code:
•
- The appliance does not fill with water.
•
- The appliance does not drain the water.
•
- The appliance door is open or not closed
correctly. Please check the door!
•
- The mains supply is unstable. Wait until the
mains supply is stable.
Warning! Deactivate the appliance before you do
the checks.
Problem Possible solution
The programme does not start. Make sure that the mains plug is connected to the mains socket.
18
