IDE Primary Master Submenu
Diskette Configuration Submenu
Event Log Configuration Submenu
Press <Enter> to start auto-detection for the primary IDE hard drive.
Specifies the type of hard drive. Settings for this option are Auto (default), None, and Manual.
Displays the maximum capacity of the primary IDE device.
Cylinder, Head, Precoup, Landing Zone,
Sector
Displays each setting of the primary IDE device.
Sets the access mode of the primary IDE device. The options are Auto (default), CHS, LBA, and Large.
Sets the PIO mode of the primary IDE device. The options are Auto (default), Mode 0, Mode 1, Mode 2, Mode 3,
and Mode 4.
Sets the ultra DMA setting of the primary IDE device as either Auto (default) or Disabled.
Configures the floppy drive interface. Options are Enabled (default) and Disabled.
Selects the floppy drive type as 1.44M, 3.5 in (default); None; 360K, 5.25 in; 1.2M, 5.25 in; 720K, 3.5 in; or 2.88M, 3.5 in.
Selects Floppy 3 mode support for the floppy drive. Options are Disabled (default) and Drive A.
Protects a floppy disk from being written to when set to Enabled. When this option is set to Disabled (default), the floppy disk is not
protected unless the write-protect tab is in place.
