HAVE A QUESTION? CALL HART CLIENT CARE at 800-
252-2818, or EMAIL US AT [email protected] 6. Once the Access Point has been connected to the power outlet and your Network port,
the Power Status (green), Wireless indicator (blue), and WAN Status (blue) should be lit
(see below).
The access point is now ready to use!
The Access Point must be connected in order to transmit. Remember to connect
the access point before testing communication with the scanners or scanning
any live Inventory data.
7. Plug the access point labeled SECONDARY into any power outlet on the Sales Floor.
Do not connect the Secondary Access Point to a Network port.
8. Place the Secondary unit in a central location on your Sales Floor. This will maximize
the coverage during inventory.
9. Once the secondary unit has been plugged in and connects with the Primary access
point, the Power Status (green), and Wireless indicator (green) should be lit (see
below).
Page 10
If you cannot establish a connection with the Access
Point, contact Hart Client Care for assistance.
800-252-2818
Power
Wireless
WAN Status
Power
Wireless
Remember: The Primary access point must be connected to your Juniper router and
fully operational for the Secondary access point to work.
VERY IMPORTANT!!!
1. Do not place a secondary access point too close to the primary. This will not
increase the range of coverage.
2. Do not connect a the Secondary access point to a Network port.
