HAVE A QUESTION? CALL HART CLIENT CARE at 800-
252-2818, or EMAIL US AT [email protected] SET UP ACCESS POINTSSET UP ACCESS POINTS
WiFi Connectivity Overview
The Hart Systems NexGen Inventory System provides instant communications at the end
of each sticker. The Internet reports are updated in real-time.
Each location was provided two Access Points. One Access Point should provide sufficient
coverage for Inventory. The other access point can be used to provide additional
coverage. If you use both Access Points, please keep them at least 150 feet apart
from each other.
The Access Point is connected into the designated Network port in your store. The user
needs to simply plug the access point into the port.
VERY IMPORTANT!!!
1. If used, do not place the secondary access point too close to the primary. Also,
Do not plug the secondary access point into any Ethernet/Network port.
The CradlePoint router (“Access Point”) will be connected to your existing network
connection.
To set-up the Access Point:
1. Clear a flat surface area with access to a power outlet and your Juniper router.
2. Place the following items in the area:
Access Point labeled “PRIMARY”
Scanners
Hart Control ID
3. Connect the power adapter for the PRIMARY Access Point into the port on the back
and then plug into an available outlet.
4. Insert one end of the Ethernet cord into the blue port on the back of the access point
Power Switch
Power Adapter Port
Blue Port
Page 9
5. Insert the other end of the Ethernet cord directly into port 2 of your Juniper router.
