Section 18
Page 5 Issue 1
45 Fit the black rubber clutch gaiter over the
operating rod and pull back over the cylinder to
allow access to the adjuster.
46 Pass the adjusting rod through the smaller
hole in the top of the clutch fork and refit the
domed adjuster and 1/4" plain locknut with the
domed end of the adjuster towards the clutch
fork.
47 Adjust until approximately 2-3 mm of play
remains, then lock the adjuster into place with
the 1/4" plain locknut. Ensure that the operating
rod is fully extended prior to adjusting.
48 Finally fit the clutch gaiter in place to
prevent debris from entering the bell-housing
and secure the hose using the 2 "P" clips and
rivets provided.
