ECLIPSE
7
PROGRAMMING THE REMOTE RECEIVER
Early transmitters & receivers operate on a frequency of 418MHz. Models for
2007 & on operate on 433MHz. Identifying the frequency is described under the
operational notes below.
1. Power to the control box must be on.
2. Press and release the “Press to Learn
Transmitter” button on the bottom of the
receiver box. The receiver is in program mode
when the red light comes on.
3. For Gray Button Key FOBs:
Press and
release
ANY button on the remote. It is
recommended to use the
STOP button. The
red light will go out after the receiver learns
the remote signal.
CAUTION
FOR THE GRAY BUTTON REMOTES, IF A FUNCTION
BUTTON IS PRESSED DURING THE LEARNING PHASE
,
THE RECEIVER LEARNS THE TRANSMITTER SIGNAL
THEN THE AWNING WILL THEN PERFORM THE FUNCTION
. USE CARE TO AVOID UNEXPECTED
AWNING MOVEMENT
.
4. For Key FOBS w/ Antenna:
Press and release the STOP button on the
remote. The red light will go out after the receiver learns the remote signal.
NOTE: Pressing the stop button will cause the blue up arrow button to
default as the close (retract) function.
If a function button is pressed to train the receiver, it will be programmed as
the retract button. Example: Pressing the bottom button will program the
bottom button for retract and the top button as extend.
OPERATIONAL NOTES:
• Transmitter and receiver must match in
frequency (418 MHz or 433 MHz).
Gray button Key FOBS are marked with a
label for 418MHz or 433MHz frequency. Key
FOBS w/ antenna are 433MHz.
418 MHz receivers are marked "RR24". 433
MHz receivers are marked "RR"
• The receiver exits the program mode after ten
seconds.
• If the light does not come on, the memory is
full and must be cleared.
• If the light does not go out in above, the receiver already knows the transmitter's
signal or the battery in the remote needs to be replaced.
• To clear the memory: PRESS AND HOLD the transmitter learn button. While holding the
button, the indicator light should be OFF for the full 5 seconds then come on.
• The system may be programmed for up to 5 remotes. Additional remotes may be
ordered separately.
DR020
TO
EYE PORT
on RP24
Program
Mode
Press to Learn
Transmitter
UP
Program
Button
Indicator
Light
DR026
418 MHz
433 MHz
Stop
Stop
FCC ID OJM-CMD-KEYX-XXX
315MHz
418MHz
433MHz
FCC ID OJM-CMD-KEYX-XXX
315MHz 418MHz
433MHz
433 MHz
OR
Rear
Label
