ECLIPSE
5
MODE SWITCH
OFF...........................The center position shuts the system down. The awning cannot
be extended or retracted in this mode. The auto-retract system is
also disabled.
CAUTION
IT IS STRONGLY RECOMMENDED THAT THE POWER SWITCH BE SET TO OFF WHENEVER
THE AWNING IS NOT BEING OPERATED AND DURING TRANSPORT
. THIS ACTS AS A SAFETY
TO PREVENT THE AWNING FROM BEING ACCIDENTLY OPENED
.
POWER ON .............The bottom position activates the patio switch and provides
power to the awning.
A
UTO-RETRACT ON...The top position activates the patio switch and the Auto-Retract
system and provides power to the awning.
When the switch is placed in the POWER ON or Auto-Retract ON position, the
switch will illuminate to indicate the system is active.
PATIO SWITCH
This is a two position momentary contact switch. This description also applies to
Eclipse models with an exterior switch or any additional patio switches that may
be installed.
E
XTEND ..................Press and release the switch. The awning automatically
opens. To stop the awning before it is open, press and
release the extend switch a second time; or, switch the
MODE
switch to the OFF position.
RETRACT ................Press and release the switch. The awning automatically
retracts until it is fully closed. To stop the awning before it is
closed, press and release the retract switch a second time;
or, switch the
MODE switch to the OFF.
SENSITIVITY SWITCH
HI...........................Hi is the least sensitive and responds to winds approximately
equal to 12 mph.
MED ......................Medium responds to winds approximately equal to 9 mph.
LOW......................Low is the most sensitive and responds to winds
approximately equal to 6 mph.
NOTE: If the sensitivity switch is not installed, the system defaults to the
medium setting.
OPERATING THE CONTROLS
For Standard operation:
• Set the
MODE switch to POWER ON or AUTO-RETRACT ON.
• Press and release the Patio Switch to extend or retract the awning.
To activate the Auto-Retract:
• Set the MODE switch to AUTO-RETRACT ON and set the WIND SPEED
(sensitivity) switch to the desired level.
