UPDATED: 6/2014 Instruction Manual IM-268-11 2014© Bally Refrigerated Boxes, Inc. 9
Part Four: Completing the Bally Installation
A. Trim door wiper gasket (if necessary) from the inside bottom of door. The wiper gasket should gently touch the
threshold when the door is in the closed position. Adjust hinges and latch if necessary (shims provided in
Miscellaneous Box #1)
B. After all locks are engaged, it is very important to secure the plug buttons over the Speed-Lok holes. These
buttons are in Miscellaneous Box #1)
C. Make sure all of the protective plastic is removed from the panels and the job site debris is cleaned up.
D. Inform the electrician that he is now able to complete connections to door light and Pressure Relief Port (if on a
separate circuit) Please note that it is not recommended to hook up door heaters until the mechanical
refrigeration is fully operational. The heat will melt the door gasket.
E. After the installation is complete use a silicone caulk between the outside vertical panels and the concrete floor. If
large gaps exist, make certain to first till the voids with expanding foam prior to sealing with caulk. Apply sealant
to building floor if water tight seal.
F. If installing an outdoor Bally Box with a membrane roof, make sure all the termination bars are securely fastened
and that all exterior joints have been caulked to prevent water leaks. All outdoor Walk-Ins must be protected
against the weather by a roof of some type, refer to “Instructions for Membrane Roof” to properly install. We can
also supply a standing seam aluminum roof where specified; Bally will provide separate installation instructions as
needed for these products.
G. You are now ready to hang evaporators and connect refrigeration. See separate instructions supplied by the
manufacturer of the refrigeration’s mechanical equipment.
Installation Reference Information
Please Fill in the spaces below and retain this manual for easy reference.
Purchaser’s name and address:
Date Installed:
Name of Installer: Installer’s Phone Number:
Walk-In Serial Number (from plate above door):
Refrigeration System Model Numbers:
Refrigeration System Serial Numbers:
Notes:
Bally Refrigerated Boxes, Inc.
1-800-24BALLY
sales@ballync.com
Phone: 252.240.2829 | Fax: 2522400384
135 Little Nine Drive, Morehead City, NC 28557
