AVERATEC Brand's Products

GoStudio

Table of Contents SECTIONS 1 2 3 4 5 6

OVERVIEW

Input/Output Description

Gain Control

Switches

The gain control determines how much amplification is applied to the

audio signal in the first stage of the GoStudio’s audio processor.

Thisstageissometimescalled“pre-gain.”Pre-gainisusedwhenthe

incoming audio signal is at a very low level and the signal must be

amplified for the best results. Pre-gain is most often needed when

using microphones, since microphones usually output very low-

levelsignals.Butbecareful;applyingtoomuchpre-gaincancause

distortion!

Thegaincontrolswitchsettingsprovidepre-gainasdescribedbelow:

off: No pre-gain is applied. Use this setting for line-level sources.

auto: This setting applies pre-gain that adjusts to the input audio

signal. The pre-gain is automatically reduced when the input signal

gets louder. This setting can be used with microphone or line-level

inputs.

low: A low amount of pre-gain is applied. This setting tends to work

best when using microphones in loud situations. This setting can also

be used for non-microphone sources that are a little too quiet.

high: A high amount of pre-gain is applied. This setting should be used

when recording very quiet or distant subjects using microphones.

It’s important to note that the gain control switch labeled gain 02 is

only used when recording from the combo jack inputs. This allows

you to dial in the appropriate level of pre-gain for each source. In

this case, the gain 01 switch controls the pre-gain of the combo 01

input, while the gain 02 switch controls the pre-gain of the combo

02 input. When recording from the 3.5mm input or the on-board

microphones, the gain 01 switch controls the pre-gain of both the

left and right stereo channels.