6.
Unplug the connector that runs from the control panel
board to the main CPU PC board. Remove the
connector from the main CPU PC board.
7. Remove the top cover.
Replace 1.
Push the carrier assembly to the left.
2.
Lay the cover in place and lift the right side. Plug in
the connector to the main CPU PC board.
3.
Tilt the cover toward you till the front edge is in place.
4.
Push down the cover. You will hear a "snap" as it
goes into place.
5.
Tighten the two screws (Figure 1, #1).
6.
Replace the ribbon cartridge and the paper cover.
7.
Perform the self-test.
ImageWriter II rev. Nov 88 Take-Apart / 2.3
