o TAKE-APART
Materials Required
Medium Phillips screwdriver
Small Phillips screwdriver
Small flathead screwdriver
Long, thin needlenose pliers
Set of jeweler's screwdrivers
Housing and
To separate the housing and the paper tray:
Paper Tray
1.
Remove the two plasticized wire paper-support rods
(one from the SheetFeeder and one from the paper
tray) by pulling the rods straight out of their holes. (For
the location of the rods, refer to the SheetFeeder
Illustrated Parts List.) Keep the customer's rods to put
on the replacement housing and/or paper tray.
2.
Unplug the connector (Figure 1, #1).
3.
Remove the two screws (Figure 1, #2) that hold the
connector plate and mounting springs.
4.
Remove the two screws (Figure 1, #3) from the metal
clamps that hold the rear housing. Remove the rear
housing.
5.
Remove the paper guide springs (Figure 1, #4).
6.
Remove the paper guide (Figure 1, #5).
7.
Remove the two pivot pins. One is on the left and one
is on the right side of the SheetFeeder (Figure 1, #6,
shows the left side).
8.
Use a small flathead screwdriver to gently pry the two
pivot shafts out. One is on the left and one is on the
right side of the SheetFeeder (Figure 1, #6, shows the
left side).
9.
Lift the plastic paper tray hinge (Figure 1, #6) away
from both sides. Do not attempt to separate the
housing from the paper tray until after the next step.
10.
Lay the SheetFeeder right-side down. Locate and
remove the spring (Figure 1, #7) on the left side of the
SheetFeeder.
11.
Slide up the paper tray detent plate (Figure 1, #8) to
free it from the frame. Gently pry the plate loose.
12.
Separate the housing and the paper tray assembly.
6.4 / SheetFeeder rev. Mar 88 ImageWriter II
