96.11.13.15.58
Color LaserWriter 12/660 PS 3–6
problem is likely in the application and the ROM upgrade will
not help.
If possible, try printing the problem file to a printer with version
2.0 ROMs. If there is no improvement, then the problem is
elsewhere.
• NetWare port number not set properly
When setting the NetWare port number through the Apple
Printer Utility, the number did not stick.
• Changing AppleTalk type fails
Changing the AppleTalk “type” on version 1.0 ROMs fails
when PAPTest is run through a LocalTalk port. (Unlikely to
affect normal user).
• EtherTalkZone and LocalTalkType strings
EtherTalkZone strings and LocalTalkType strings did not take
input longer than 31 characters. (Unlikely to affect normal
user).
• LocalTalk ports turns off; EtherTalk remains active
In some cases, the LocalTalk port turned off after printing a
very large number of PostScript test files to a printer using both
EtherTalk & LocalTalk ports, even though the EtherTalk port
remained active and could be seen from any host. (Unlikely to
affect normal user).
• Specific PostScript Code resets printer
Sending the following PostScript code caused the printer to
reset itself (unlikely to affect normal user):
[(%disk1%) <</InitializeAction 1>> setdevparams]
• PowerPoint v3.0 gradients
Some PowerPoint slides containing complex gradients or
patterns would freeze the printer.
• TraySwitch not saved
Enabling the TraySwitch feature on a Color LaserWriter
12/600-J (Kanji version) did not survive power cycles.
• One-byte PostScript filename on printer hard drive
Creating a one-byte long PostScript filename on a printer’s hard
disk caused an I/O error. (Unlikely to affect normal user).
• Configuration switch and image data
This issue only affects printing from PC computers using the
parallel port. Once the printer’s configuration switch was used,
