PAGE 4
CONTINUOUS CONTROL PEDAL: (Continued)
This pedal is ideal for controlling speed swells in either direction from
slow to fast and back or vice versa. Whatever position the pedal is left in will determine the speed at which the REVOLVER comes
to rest at. This makes available many more speed settings than using only the footswitch...all of which are available on the fly.
The lever located on the Continuous Control Pedal, when pushed to the right with your foot, duplicates the ON / OFF function of the
footswitch. When the Red LED on the pedal is lit the REVOLVER will rotate. Likewise, when the LED is unlit the REVOLVER will
not rotate.
Like the footswitches ON / OFF button, this lever is not a power switch and will not turn
the REVOLVER’S circuitry off when not in use. Again...always use the 3 position power
switch located on Front Panel for this function.
The REVOLVER has an automatic Brake System which is activated by both the footswitch and the Continuous
Control Pedal when going from a faster speed to a slower speed. The Brake releases when the rotational speed which is determined
by either the Slow Fine Tune or the Continuous Control Pedal has been reached.
FUSE:
This is the A.C.s’ (Alternating Current) main fuse and provides electrical current protection from outside A.C. fluctuations,
as well as possible circuitry failure damage. Should the fuse blow, replace it with the same rating in a slo-blo type package. The
Domestic U.S. REVOLVER’S requires a 1 Amp slo-blo fuse. The Export
REVOLVER’S use a .500 Milliamp Slo-Blo fuse.
The REVOLVER is protected by two fuses one on the Rear Panel and one inside
the cabinet. Should a problem arise, always check both fuses. As always, be sure to
disconnect the unit to avoid possible injury and/or causing more damage to the
REVOLVER.
NOTE: Like tires on a car, spare fuses are always a measure of good insurance.
Your REVOLVER was carefully constructed with reliability in mind! Given the
proper care and maintenance, it will deliver years of trouble free service. However,
any pro guitarist who is out there gigging will tell you; spare tubes and fuses are a
must for the fabled cord bag and may someday be worth their weight in gold.
SPEAKER JACK:
The REVOLVER’S Speaker Jack is located beside the fuse holder. Do not confuse this jack with the
Footswitch Jack located on the Front Panel. The REVOLVER is an 8 Ohm speaker cabinet and does not have its own amplifier.
The stock speaker is a 90 Watt Celestion Black Shadow, which is made exclusively
for Mesa/Boogie.
ON / OFF Lever (switch)
FRONT PANEL FUNCTIONS:
(Continued)
REAR PANEL FUNCTIONS:
FUSE
8 OHMS
WARNING:
To reduce risk of fire and/or
electric shock, replace only with
117 V.
1.25 A
60 HZ.
MUSICAL INSTRUMENT SPEAKER ENCLOSURE
8 OHMS
FUSE
WARNING:
To reduce risk of fire and/or
electric shock, replace only with
same type and rating of fuse.
Unplug power before removing f
use. Do not expose this unit to
rain or moisture. Do not remove
bottom cover.
117 V.
1 A
60 HZ.
OOGIE
B
M
ESA
MUSICAL INSTRUMENT SPEAKER ENCLOSURE
