
PAGE 3
REMEMBER...in order to turn the REVOLVER off when it is not in use, always use the 3 position power switch which is located on
the Front Panel.
CONTINUOUS CONTROL JACK:
This is where the REVOLVERS’ Continuous Control pedal connects to the unit. This is
a standard 1/4 inch stereo jack.
CONTINUOUS CONTROL PEDAL:
This pedal allows maximum control over the REVOLVER’S rotational speed. It func-
tions similarly to a normal volume pedal and is not unlike the gas pedal in a car. When it is pushed all the way forward (or down) the
REVOLVER will operate at its fastest speed and at its slowest rate of speed when the pedal is pulled all the way back (or in its up
position.)
Be aware that the Slow Fine Tune Control on the REVOLVER’S Front Panel can be used as
a Trim Control for the Continuous Control Pedal. If the Slow Fine Tune control is set low, the
Continuous Control Pedals slowest and fastest speeds will both be slower. If the Slow Fine Tune
control is set high, the Continuous Control Pedals slowest and fastest speeds will be faster.
Cable to Footswitch Jack on the REVOLVER'S
Front Panel.
ON / OFF
ON
FAST / SLOW
SLOW
REVOLVER
ON / OFF
This button (switch) which is
linked to the Red LED and is
in its ON position when the
LED is lit, activates the
REVOLVER’S internal
cabinet.
This is not a power ON / OFF
switch, although it will stop the
rotation of the internal
speaker, it will not turn off the
REVOLVER’S electrical
circuitry.
FAST / SLOW
This button (switch) which is
linked to the Green LED and is
in its ON position when the LED
is lit, controls the
REVOLVER’S two speeds.
The REVOLVER is in its slow
running mode when the LED is
lit and in its fast running mode
when unlit.
SLOW FINE TUNE
REVOLVER
R
FAST
SLOW
OFF
FOOTSWITCH
CONTINUOUS
CONTROL
OOGIE
B
M
ESA
Continuous Control Pedal
in its slowest position
FRONT PANEL FUNCTIONS:
(Continued)