7
Installation
Technical information for
the installer
Oven
• After removing the oven
from its packaging,
before making the
connections place it on
the polystyrene foam
base to protect it from
damage.
• Do not attempt to lift the
oven by the handle. Lift
at the sides as shown in
the figure (see arrow).
• Check that the appliance
has not been damaged in
transit.
• Oven dimensions and
kitchen unit dimensions
are shown in the figure
opposite.
• Kitchen units in contact
with the oven must be
heat resistant (80° C min).
• If plastic laminates or
cement are not
sufficiently heat-
resistant, warping,
bubbling or detachment
of the finish may result.
• Install the oven in the
housing, lifting it at the
sides, taking care not to
trap the wires of the
electrical supply cable.
• For correct ventilation,
follow the ventilation
opening directions shown
in the figure
• (500 min x 80 mm and
500 min x 50 mm inside the
cabinet).
• Secure the oven to the
kitchen unit with screws
(A) as shown.
During oven installation, care
must be taken to ensure that
the sides are not touching the
front edges of the housing or
adjacent drawers and doors
(see picture).
4gb53201.fm5 Page 7 Wednesday, June 19, 2002 2:15 PM
