Opening the door after the programme has started
First set the machine to pause by pressing the START/PAUSE button.
● If the messages «Pause» and «Door unlocked» appear alternately on the
display, the door can be opened.
● If the messages «
PPaauussee
» and «
DDoooorr uunnlloocckkeedd
» don’t appear on the display, this
means that the machine is already heating, that the water level is above the bottom
edge of the door or that the drum is turning: in this case the door can not be
opened.
● If you cannot open the door but you need to open it you have to switch the machine
off by turning the selector dial to O. After about 3 minutes the door can be opened
((ppaayy aatttteennttiioonn ttoo tthhee wwaatteerr lleevveell aanndd tteemmppeerraattuurree!!))
. To restart the programme again,
turn the selector dial on the previous programme and press the START/PAUSE
button.
At the end of the programme
The machine stops automatically. The START/PAUSE button pilot light goes off,
flashing
0.00 appear on the display and the acoustic signal sounds for some
minutes.
If the Rinse Hold or Night Cycle option has been selected, the
START/PAUSE pilot light goes off, the messages «Door locked» and «Rinse hold»
appear on the display, the door is blocked to indicate that the water must be
emptied out.
To empty out the water please read the steps on the «Rinse hold» option
paragraph.
Turn the programme selector dial to O to switch the machine off. Remove the
laundry from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the
door open to prevent the formation of mildew and unpleasant smells.
24
Use
132969591.qxd 18/01/2008 11.18 Pagina 24
