When discharging into a standpipe ensure
that the top of the standpipe is no more
than 90 cm (35.4'') and no less than 60 cm
(23.6'') above floor level.
The drain hose may be extended to a max
imum of 4 metres. An additional drain
hose and joining piece is available from
your local Service Force Centre. The joining piece must have an internal diameter of 18
mm.
If your drain hose looks like this (see be
low) you do not require the “U” piece”. Just
push the hose firmly in to the standpipe.
2.
Onto a sink outlet spigot.
If the outlet spigot has not been used be
fore, remove any blanking plug that may
be in place.
Push the drain hose onto the spigot and
secure with a clip, ensure a loop is formed
in the drain hose (see diagram) to prevent
waste from the sink entering the appli
ance.
If you intend to drain the hose from the ma
chine into a sink, make sure that the sink is
empty and the plug hole is not blocked.
Use the plastic “U - Piece” supplied.
Before connecting up the machine to new pi
pework or to pipework that has not been used for some time, run off a reasonable amount
of water to flush out any debris that may have collected in the pipes.
loop
Installation
33
