Water-stop device
The inlet hose is provided with a water stop device,
which protects against damage caused by water
leaks in the hose which could develop due to nat
ural ageing of the hose. This fault is shown by a
red sector in the window «A» . Should this occur,
turn the water tap off and refer to your Service
Centre to replace the hose.
WARNING!
Installation should comply with local water authority and building regulations’ re-
quirements.
The appliance must be connected to a cold water supply.
A minimum water pressure of 0.05 MPa (0.5 bar) is required for safe operation of the
appliance.
If you cannot make the cold water connection direct from the rising mains, you may be
able to operate the appliance from your cold water storage system.
There should be a minimum vertical distance of 5.02 m (16.5 ft) between the appliance’s
inlet and the bottom of the water storage tank.
Water drainage
This appliance is designed to be permanently plumbed into your home's drainage system
using one of the following methods.
1.
Into a drainage standpipe
Firstly form a hook in the end of the drain
hose using the “U” piece” supplied.
Place the drain hose into your standpipe,
which should have an internal diameter of
approximately 38 mm thus ensuring there
is an air break between the drain hose and
standpipe.
38 mm (11.2”)
standpipe
diameter
30 cm(12”)
32
Installation
