H & T CABINETS F-41013 (02-13)
3
GENERAL
INTRODUCTION
Wittco Holding & Transport Cabinets are produced with quality workmanship and
material. Proper installation, usage, and maintenance of your cabinet will result in many
years of satisfactory performance.
It is suggested that you thoroughly read this entire manual and carefully follow all of the
instructions provided.
Wittco Holding & Transport Cabinets provide an efficient means of transporting and
holding bulk prepared foods at proper serving temperatures.
INSTALLATION
Before installing, verify that the electrical
service agrees with the specifications on
the rating plate located on the lower
back corner of the cabinet. If the supply
and equipment requirements do not
agree, do not proceed with unpacking
and installation, Contact Wittco
Customer Service Department
immediately. (Fig. 2)
UNPACKING:
The Cabinet was inspected before
leaving the factory. The transportation
company assumes full responsibility for
safe delivery upon acceptance of the
shipment. Immediately after unpacking,
check for possible shipping damage to
the cabinet.
If the cabinet is found to be damaged,
save the packaging material and
contact the carrier within 15 days of
delivery.
Carefully unpack and place in a work
accessible area as near the installation
position as possible.
1. Open the door and carefully
remove any packaging materials
and the retaining straps that hold
the wire plate racks (Banquet
Carts) or the tray slides and tray
slide upright side supports
(Holding & Transport Cabinets).
2. Peel off vinyl protection film.
3. 1826-7-DBL-IS ONLY:
This cabinet is simply two (2)
1826-7-IS cabinets stacked on
top of each other. One (1)
cabinet will come with casters
and a stacking assembly on top.
The other cabinet is without
casters. This cabinet requires
two people to lift and should be
placed inside the stacking kit that
was shipped with the bottom
cabinet. Stacking kits fit only one
way between the cabinets. If for
any reason either one or both
cabinets do not fit within the
stacking kit provided, please
contact the service department at
414-434-4716.
