Before working with the machine
3
2.3 Electrical Safety
The electrical safety of this machine is guaranteed only if it is connected to a correctly installed protective
circuit and a residual current circuit breaker. It is very important that this basic safety requirement is test-
ed and in case of doubt the house installation is checked by a qualified electrician.
Winterhalter cannot be held responsible for damage caused by a missing or broken earthing system (e.g.
electrical shock).
2.4 Safety Instructions for Maintenance and Repairs
Maintenance work and repairs may only be performed service technicians authorized by Winterhalter.
Improper maintenance or repairs may cause significant danger for the user, for which Winterhalter is not
liable.
When performing maintenance and repair work, unplug the powder dosing device from the power net-
work. Electricity consumers (heating element, frequency inverter, ...) are under voltage until the on-site
mains disconnect switch has been operated.
Only original Winterhalter replacement parts may be used for maintenance and repairs. If original re-
placement parts are not used, the warranty is invalidated.
A damaged or leaking machine can endanger your safety. In case of defects, switch off the machine im-
mediately. Switch off the on-site mains disconnector (main switch). Only then is the machine without
power.
Do not operate a damaged machine. In case of defects resulting from an unknown cause, switch off the
machine, and switch it on again only when the defect has been rectified.
Contact your installer or electrician if the on-site water or electricity supply is the cause of the malfunction.
Notify an authorized service technician or your retailer if another fault has occurred.
If the mains connecting line of this device is damaged, it must be replaced by the Winterhalter or its Cus-
tomer Service or another qualified person in order to prevent hazards. The power cable must be
H07 RN-F type or equivalent.
2.5 General safety notes
Read through the safety notes and operating instructions in this manual carefully. Retain the operating
instructions for future reference. Winterhalter Gastronom GmbH does not assume liability or warranty in
case of non-adherence to these safety and operating instructions.
Do not make changes, additions or reconstructions in the dishwasher without the approval of the manu-
facturer.
Use the dishwasher only after you have read and understood the operating manual. Allow the Win-
terhalter Customer Service Department to provide information about the operation and functioning of the
dish washer. Always operate the machine as described in this operating manual.
Train the operating personnel as regards handling the machine and inform them about the safety notes.
Repeat the training sessions at regular intervals to prevent accidents.
For your safety, test the local fault current circuit breaker (FI) regularly by pressing the test button.
Close the local water shut-off valve after the work is complete.
Switch off the local mains disconnector after the work is complete.
3 Before working with the machine
Have the machine set up by an authorized service technician or your dealer ( 15).
Get the machine connected as per the locally applicable standards and the regulations of the authorised
mechanics (water, waste water, electrical system) ( 16 and 17).
After connecting the water and the power properly, contact the relevant Winterhalter dealer or your dealer
for the commissioning of the machine and for providing training in its operation. Get yourself and your op-
erating personnel trained in the operation of the machine.
