041-135-B1-001 Rev. A 3
Total Power Solutions
Figure 4-1, Oil recommendations for ambient temperature.
3.0 Engine Oil Recommendations
Oil affects performance and service life for the engine.
Always use 4-stroke automotive detergent oil. The engine
can hold .49 U.S. qt (.46 L) of oil.
Synthetic SAE 10W-40 is recommended for general
use. Other viscosities shown in the chart may be used
when the average temperature in your area is within the
recommended range (see Figure 6).
The SAE oil viscosity and service category are in the API
label on the oil container. Use API SERVICE category SJ or
later (or equivalent) oil.
4.0 Changing Engine Oil
1. Open and remove the oil maintenance cover (fuel valve side of the generator).
2. Placeasuitablecontainerbelowtheenginetocatchtheusedoil,thenremovetheoilllercap/dipstickusing
the slotted end of the oil drain pipe.
3. After removing the dipstick, screw the oil drain pipe into the generator.
4. Allow the used oil to drain completely (see Figure 7), then reinstall the drain plug and sealing washer. Tighten
the plug securely.
Note: Improper disposal of engine oil can be harmful to the environment and may violate local and federal
laws. Dispose of the used oil in accordance with all local, state and federal laws.
5. Withthegeneratorinalevelposition,lltotheouteredgeoftheoillterholewiththerecommendedoil(see
Figure 8).
6. Screwintheoilllercap/dipsticksecurely.
7. Reinstall, close, and latch the oil maintenance cover.
Note: Always wash your hands with soap and water after handling motor oil.
Figure 7, Draining Oil Figure 8, Filling Oil Limit
Upper Limit
Oil Drain Plug
Oil Maintenance
Cover
Dipstick
AMBIENT TEMPERATURE
Drain Screw
Hot engine is a BURN HAZARD. The engine should be warm to the touch but not hot when changing
the oil. Draining warm oil assists rapid and complete draining.
CAUTION!
Recommended Oil
SAE 0W-40 SAE 10W-40
0° F 32° F 113° F
(-18° C) (0° C) (45° C)
