EVAPORATOR INSTALLATION
ON A WORK BENCH, INSTALL EVAPORATOR REAR BRACKET AND HARDLINES WITH PROPERLY LUBRICATED O-RINGS.
(SEE FIGURE 11, PAGE 12, AND FIGURE 16, PAGE 17.)
INSTALL FRONT MOUNTING BRACKET ON EVAPORATOR USING (2) 1/4-20 X 1/2 HEX BOLTS AND TIGHTEN AS
SHOWN IN FIGURE 6 BELOW.
LIFT EVAPORATOR UNIT UP UNDER THE DASHBOARD SEE FIGURE 7. SECURE LOOSELY TO THE FIREWALL FROM THE
ENGINE COMPARTMENT SIDE USING (2) 1/4-20 NUT AND WASHER, SEE FIGURE 7 BELOW.
USING (2) #14 X 3/4 SHEET METAL SCREW w/ 1/4 FLAT WASHER SECURE THE FRONT EVAPORATOR MOUNTING BRACKET
TO THE INNER COWL. SEE FIGURE 7 BELOW.
VERIFY THAT EVAPORATOR UNIT IS LEVEL AND SQUARE TO THE DASH, THEN TIGHTEN ALL MOUNTING BOLTS.
(NOTE: TIGHTEN THE BOLT ON FIREWALL FIRST, THEN THE FRONT MOUNTING BRACKET SCREWS.)
1969-70 MUSTANG w/ AC GEN IV
904069 REV A 1/30/08, 69-70 MUSTANG w/ AC GEN IV EVAP INSTR PG 9 OF 23
FIGURE 6
EV
AP
FRO
NT
BRK
T
641271
DRIVER SIDE EVAP
MOUNTING HOLE
FIGURE 7
(2) #
14 X
3/4
SHE
ETMET
AL
SCREW
w/ 1
/4
FLA
T W
ASHER
PASSENGER SIDE EVAP
MOUNTING HOLE
S
B
Y
9
