BEFORE STARTING THE INSTALLATION, CHECK THE FUNCTION
OF THE VEHICLE (HORN, LIGHTS,ETC.) FOR PROPER OPERATIONS.
STUDY THE INSTRUCTIONS, ILLUSTRATIONS, & DIAGRAMS.
CONDENSER ASSEMBLY & INSTALLATION
COMPRESSOR & BRACKETS
PULLEYS
OEM HEATER
WIRING/VACUUM
HARNESS
MOLDED GROMMET
HOOD LATCH
AND SUPPORT
ASSEMBLY
BATTERY &
BATTERY TRAY
INNER
FENDER PANEL
OUTER
FENDER
HEATER HOSE
CLAMP
OEM
BLOWER MOTOR
ASSEMBLY
RADIATOR
ENGINE COMPARTMENT
BATTERY AND BATTERY TRAY (RETAIN). SEE FIGURE 1.
DRAIN RADIATOR
HOOD LATCH ASSEMBLY (RETAIN) INCLUDING HOOD LATCH SUPPORT
HEATER BLOWER MOTOR ASSEMBLY (DISCARD). TO REMOVE THE HEATER BLOWER MOTOR
ASSEMBLY (UNDER HOOD) AND THE AIR DISTRIBUTION SYSTEM (UNDER DASH), THE FACTORY
MANUAL INDICATES DOING THE FOLLOWING: "REMOVE RIGHT LOWER ROCKER MOLDING.
REMOVE LOWER FENDER ATTACHING BOLTS. REMOVE SKIRT TO FENDER AND SKIRT
TO REINFORCEMENT SCREWS. PULL OUT ON LOWER PORTION OF FENDER, MOVING
THE SKIRT AWAY FROM THE FENDER FLANGE AND FIREWALL. BLOCK THE SKIRT WITH
A 2 x 4 BLOCK OF WOOD".* TO AVOID DAMAGE TO PAINT AND SHEET METAL, AND FOR EASE
OF REMOVAL AND REPLACEMENT OF COMPONENTS; VINTAGE AIR SUGGESTS THAT THE RIGHT
FENDER BE REMOVED AND INNER PANEL BE LOWERED. SEE FIGURE 3.
OEM HEATER HOSES (DISCARD). SEE FIGURE 1.
REMOVE OEM HEATER WIRING/VACUUM HARNESS MOLDED GROMMET. SEE FIGURE 1.
INSTALL 1
½” PLUG IN FIREWALL SEE FIGURE 1a BELOW.
REFER TO SEPARATE INSTRUCTIONS INCLUDED WITH
THE CONDENSER KIT TO INSTALL THE CONDENSER.
BINARY SWITCH INSTALLATION (REFER TO CONDENSER INSTRUCTIONS)
REFER TO SEPARATE INSTRUCTIONS INCLUDED WITH
THE BRACKET KIT TO INSTALL THE COMPRESSOR BRACKET.
IN MOST INSTANCES THE BELT LENGTHS WILL REMAIN THE SAME.
REMOVE THE FOLLOWING:
33173-VUI
1 ½” PLUG
FIGURE 1
FIGURE 1a
