1970-78 CAMARO w/o AC
CENTER LOUVER
TEMPLATE
CENTER LOUVER MOUNTING HOLES
OEM
HOLE
1970-78 CAMARO w/o AC
CENTER LOUVER
TEMPLATE
CUT OUT TEMPLATE PROVIDED ON PAGE 27. SLIDE THE TEMPLATE UNDER THE DASH AS SHOWN BELOW
IN FIGURE 14. ALIGN THE LEFT AND RIGHT SIDE OF TEMPLATE WITH CREASE IN THE DASH AS SHOWN
BELOW IN FIGURE 14 &14a. ALIGN BOTTOM EDGE OF THE TEMPLATE ALONG THE BOTTOM EDGE OF
DASH AS SHOWN BELOW IN FIGURES 14 & 14a.
ONCE TEMPLATE IS ALIGNED CORRECTLY AND TAPED INTO PLACE, MARK MOUNTING HOLES ON
DASH. ONCE HOLES ARE MARKED IN THE CORRECT LOCATION REMOVE TEMPLATE AND DRILL
(2) 3/16” HOLES IN DASH FOR THE CENTER LOUVER BEZEL. SEE FIGURE 14a BELOW.
FIGURE 14
FIGURE 14a
